Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rakesh gupta
No, A dc transformer is not possible. A transformer secondary coil generates voltage(induced) when there is a variation of flux though its coil which is produced by pulsating current in the primary coil which is not possible with dc source. however a dc voltage regulation can be possible with dc to dc converter.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
Why we use circular(Stepped) cross section in transformer core?
Can double compression glands be used with regular cables?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
When MICC cables used ?
How is magnetic leakage reduced?
suri transmission
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
how cables go in and come out for distribution from the feeder pillar box?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
Why is negative feedback invariably preferred in closed loop system?
why zero sequence impedance measurement is not applicable for single phase GT
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
