Interested to Buy Any Domain ? << Click Here >> for more details...
what is ATS & RING MAIN UNIT in Distribution System?And its
Function.
- 2 Answers
- 8588 Views
- I also Faced
- E-Mail Answers
Answer Posted / david vk2cz
ATS is an automatic transfer switch, meaning it will accept power from 2 sources, and automatically switch to the source with available power. This can be dangerous in maintenance activities, unless it is switch to manual. Mostly used in datacentres, underground train stations and underground corridor lighting
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
Which type of questions well asked. ?
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
I want to know all basics of electrical engineering
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
what are the range of memory address in plc for L&T lx7 4A
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
What are stable systems?
How can we increase the capacity of Energy.?
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
