Answer Posted / nagesh.patwari

Pure tungsten has some amazing properties including the highest melting point (3695 K), lowest vapor pressure, and greatest tensile strength out of all the metals.Because of these properties it is the most commonly used material for light bulb filaments. It can reach high temperature before melting and therefore emit a brighter light than nichrome can. Nichrome on the other hand, although it has a pretty high melting point (1673 K) it is not as high as tungsten, but it is often used for heating devices, such as a blowdryer. An electric current can heat the filament around 2000-3300 K, which stays below the melting point of tungsten but above that of nichrome.

what are the pecularity of shaver sockets ?

1862

---

how pt is using

1896

---

what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.

3716

---

WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?

1919

---

I need HT sphere gap calibration table. Can any body help me.

1897

---

How to size fuse? How to size MCB?

1464

---

What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?

1926

---

What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.

1292

---

what is the difference b/w pvc cu conductor and cu breaded wire..?

3483

---

What does the letter CTNM in negative phase sequence relay means?

1740

---

What is meant by harmonic distortion?

1055

---

if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please

2045

---

What is inrush current?

1094

---

Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set

2146

---

block diagram of 2 ups system connected in hot stand by mode?

8006

---