What is Procedure the procedure to select CT's & PT's in
66kV and above substation
- 1 Answers
- 2275 Views
- I also Faced
- E-Mail Answers
Answer Posted / neha
There is no procedure you need to select the similar ratings of CT/PT as to the line.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which do you think is the most significant cause of energy loss in a factory?
what is RFID? thire application;
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
What is the difference between the relay and the circuit breaker?
what is the ground fault relay,which purpose it will be use,clearly tell me plz
On what basis the the size of Lightning arrester for buildings are selected ?
what is the transformer rush current?
What is the need for a controller?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
how to calculate cable size in diffrent loads?
What is an automatic controller?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
design a 3 bit synchronous and asynchronous counter using T- flipflop
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
what is the responsibility of C license holder in industry?
