Interested to Buy Any Domain ? << Click Here >> for more details...
WAT IS MEANT BY COLD AND HOT START OF A MOTOR?? HOW DOES IT
AFFECT A MOTOR'S PERFORMANCE??
- 4 Answers
- 57418 Views
- I also Faced
- E-Mail Answers
Answer Posted / sophia
Hot start and cold start refer to the temperature of the motor when starting. Hot start is usually a restart after coasting to a stop. Cold start is an initial start, after not having run for a relatively long period of time. This is important because there is usually a limit on the number of hot starts that are allowed in a certain period of time. This is due to the fact that these motors pull more current starting than when they run, and if you start them too often they can overheat.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
how to convert lv line to hv line and viseversa, any losses will occur during this process
how to calculate the settings for shaft ct protn in hydro generators
How to address the servo drive for motor
What is the function of auadag in a cro?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
what is the function of Moulded case circuit breaker, why it is called Moulded?
how much UPS neutral erath leakage current.
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
What is DTR erection?
what parameters should we check to reduce the power bill
What are the applications of autotransformers?
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
