Interested to Buy Any Domain ? << Click Here >> for more details...
why we use the 4-20 mamp signal used for transmitter.
- 5 Answers
- 10755 Views
- Tecnimont, I also Faced
- E-Mail Answers
Answer Posted / siddhesh
4-20 signal is Intrinsically safe vale of current. also it dose not get affected with EMI.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
protection relay watchdog contact operation?
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
for oil & gas industries which zone is normally preferred? why? give its example?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what are the steps I have to deal with?
Full form of KKS when use DCS.
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
why is an oxygen sensor used in a boiler stack
where proximity sensor installed on tank in loading arm application
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
in mass flow meter what is drive friquancy ?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
