What is the ratio of Grades M10,M15,M20,M25,M30,M35,M40.
Answer Posted / ashok
M5 - 1:5:10
M7.5 - 1:4:8
M10 - 1:3:6
M15 - 1:2:4
M20 - 1:1.5:3
M25 - 1:1:2
M30,M35,M40 - Design Mix Followed
Is This Answer Correct ? | 103 Yes | 6 No |
Post New Answer View All Answers
Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––
Explain the term 'Gross unit rate' and identify the items that may be included in the gross unit rate.
What is pre-stressed concrete?
What is proportion of PCC Grade G?
A Cat excavator loader of 3Lm*3 heaped capacity bucket is to be used to load blasted rock directly into a crusher of capacity (consumption) of 100L
How u can calculate the Octagon ring distance from center of raft in 275 mtr chimney slipform errection? cantact no:0993455097
which has high compressive strength between hollow block and brick masonry?
How to find the cuplock pipe qty in staging for Minor bridge?
cement mortor 1:5 for 30 m2 12 mm tk plastering so how to calcualte its rate
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
1.what is the mix proportion for cement soil compressed earth blocks? 2.how to calculate the mix proportion for cement stablised earth soil blocks?
calculate the quantity of water for 1:6 cement mortar
how to convert cement, sand aggregate quantity from M3 to kg with full description?
what are the five benefits of using standard terminology in the measurement process?
What is zoning permit?