Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ram singh chauhan
VD=MV*I*L/1000
M=milli volt
I=current
L=cable lenth
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the id1 & id2 setting in differential protection relay of CSPC?
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
does any one know where we can purchase insulation oil for high voltage oil filled cables
transformer phasor diagram under load explain it?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
what you have to see after one week or month from the day of installation of transformer ?
What safety precaution are to be taken for avoiding electric hazards ?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
IN 1000kva transformer where the oil and winding temperature sensors is connected
is it possible to test of bus bar in high rise building without completed full floor ?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
critically criticize the application of ring main unit in power system
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
