Interested to Buy Any Domain ? << Click Here >> for more details...
If cvt is most advance & effective(economically & stability)so why not use instead of VT(11 kv & 33 kv)?
- 3 Answers
- 6092 Views
- I also Faced
- E-Mail Answers
Answer Posted / jiggykops
be cause cvt cvt used in 66kv and above because at such voltage vt s cost to high
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
Which is the oldest hydropower plant in india?
how slip power recovery system work
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
What are the three constants associated with a steady state error?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
Why is the frequency not changed during transformation of electrical energy in a transformer?
battery capacity use of made?
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
What is an ideal transformer?
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
