Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / liladhardanej11
depend upon as per control supply i think normally used 110v & 127v ac
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How you calculate the repturing capacity of a HRC fuse
What is meant by celling voltage & current in excitor ?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What happens if we run alternator on under frequency?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
distribution is maximum done by a)radial b)network c) parallel d)b & c
Inductor and capacitor........power in one phase and ...... in it another phase.
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
What is Anemometer used to measure?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
What type of DC motor would you see for a lift?
what is the standard duration after failure EB power
