What is difference between Electrical & Electronic Device?
Answer Posted / santhosh kumar
Electronics deals with low voltage, high frequency. In Electrical it is quite opposit.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
difference between servo motor and synchronous motor
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Explain the difference between verilog task and verilog function?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
What is a dominant pole?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
hi, could someone help me to find a control design for syncronising panel .
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
How can maintain our H.T. motors used in cement plant. please send me procedure.
what is feed back and what are feed back amplifiers?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
What are the weight of 800KV DA,DB and DC type tower ?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.