What is difference between Electrical & Electronic Device?
- 7 Answers
- 11611 Views
- AZ Engineering, Vodafone, I also Faced
- E-Mail Answers
Answer Posted / prashant
Electronic deals with --
1) semiconductor
2) DC Supply
3) mostly working on low voltage somewhere it can work with high V/I
4)diodes SCR family, R ,L, C , and processer and SMD, IC'S are some components
Electrical deals with --
1) conductor some times semiconductors
2) AC supply
3) mostly working on higher voltages
4) motors, contractors, condenser are main material used in electrical
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
How to calculate the fuel consumption for 600kva DG genset which connecting with 25%load?
how is the testing of an REF relay? what are the test REF circuit having?
what is acceptance test in electrical engineering.
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
How would your past experience translate into success in this job?
which of the following elements is not present in stainless steel
why US countries maintains 110v and 60HZ
what is per unit calculation?looking for simple and strong explanation thk u
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
Why use the vcb at high transmission system ? Why can’t use acb?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
