What is the definition of ohms law?
Answer Posted / rajkumar
At the constant temperature, the flow of current through the conductor is directly proportional to the voltage across between the two end of conductor..
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Approach of a cooling tower is the difference between temperatures of what factors?
what is gas turbine intercooling ?
size of condotory fron voltage level
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Brief me about maintenance planning & sheduling of machine tool.
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
How to connect the chemical earthing and complete process tell me plz
What is the normal phase difference between the voltage and the no-load current in a transformer?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
i want to know that what is the eligibility critaria for ongc exam?
What is the bundle conductor?
how can we make cable shedule for controll wiring ? which details must be required for it.?