Interested to Buy Any Domain ? << Click Here >> for more details...
why hv winding is not placed near to transformer core
- 4 Answers
- 25263 Views
- I also Faced
- E-Mail Answers
Answer Posted / pranay bhaurao thengne
If we placed lv winding placed first to the limb and then hv former and hv winding ...
Due to this arrangement minimises the leakage reactance and leakage flux .
And improves mutual inductance between two windings ...
And also for cooling purposes...
And requires less amount of insulation...
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
What are IR values and what it should be for coil and for insulator
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
why the neutral point in connnection oscillates?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
how to calculate the fault in substation
the problem faced on star or delta winding connection??
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What is the use of oil in transformers?
Please define ohm’s law for a.c (alternating current)?
What is different between Circuit breaker and Isolater?
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
