Interested to Buy Any Domain ? << Click Here >> for more details...
What is the definition of ohms law?
- 7 Answers
- 11175 Views
- AZ Engineering, Ecil, I also Faced
- E-Mail Answers
Answer Posted / karthikeyan
voltage is proportional to current and inversly proportional to resistor
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
How can you sized or estimate the ligthning arrester current rating?
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
which type of motor is used in automatic swing gate
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Usage of flywheel diode in relays
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What is the Nyquist criterion regarding control systems?
how will we calculate the copper wire load..
what is earthing.how we make it,describe briefly.
What is touch potential and step potential?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
What the difference between ac and dc inductor an capacitor
