Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between static and dynamic induced emf?
- 14 Answers
- 127202 Views
- College School Exams Tests, MRF, Suraj Constructions, I also Faced
- E-Mail Answers
Answer Posted / santosh kumar. yadav
If coil or conductor is constant flux is rotating static if flux is constant coil or conductor is rotating it is dynamic.
| Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
What is float cum boost charging system?
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
How can I calculate ISF of current transformer?
Difference between drift current and diffusion current?
Explain about p.t?
How many types of colling system it trformers?
what is the control circuit for operating the clean room air shower
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
For a stable system, where should the poles of a system be in a root loci plot?
why we are using Load factor?
how to calculate fuse rating for a motor
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
