Interested to Buy Any Domain ? << Click Here >> for more details...
What Happens when oil pressure in a dg set come down to
zero.What are the trouble shooting methods?
- 1 Answers
- 3240 Views
- I also Faced
- E-Mail Answers
Answer Posted / siddhardha
actually oil pressure will be zero only in one case when the dg is in off condition. when it is in running condition it will have pressure of 4 bar . if it is not showing it may be due to two problems one is there is no sufficient oil in the engine and other is the oil pressure sensor is malfunctioning , remedy should be check the oil level in the dg and next check the oil pressure sensor the process for checking the sensor is check the continuity of it u will get the result or else replace with another sensor and check it ,,
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is heavy water and what is its use in nuclear plants ?
What is the use of metal jack plane?
any body hv a experience of L&T pget interview for mechanical thn send me question and experience to me as i hv interview on 8 th may so send me as soon as posssible on my mail id nilesh.spy2000@gmail.com
Draw L.O. system in diesel engine?
which type of que can be asked in this company?
Is your basic salary of $...... , good for you if employed?In case of any eventuailt,who is your next of kin?
Which are the sheets of metals?
Explain why is over-pressurizing an air conditioning system bad?
thermal engineering
What is the function of thermostat in cooling system of an engine ?
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
The efficiency of a pin fin with insulated tip is
On what basis can sliding contact bearings be classified? Explain?
hello i have a problem !!!! i am studying gait analysis"human walking; and i had only single camera"sony 25 frames/s" and 2 separated force plates, and there is no synchronization between the camera and the force plates!. i wrote a matlab program to calculate joints moment(sagital) using inverse dynamics methode. and there is a problem with the output data!! can you help me.
Which two elements have same percentage in proximate and ultimate analysis of coal?
