Answer Posted / r_vaya
Range is operating units of Instruments from lower to higher
Span is the gap between range.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
What are different type of instrument cable
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
How we connect a instrument with ground, Give brief explanation with help of diagram?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
How d.p. Transmitter can be applied to close tank?
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
Manipulation of dead wt. tester double piston type.
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
components of control circuit belongs to control valve
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.