how much type question asking sulfuric acid plat interview.
if not maintain acid temp. and conc. what will happen
- 1 Answers
- 4286 Views
- I also Faced
- E-Mail Answers
Answer Posted / astik gedekar
It is most important to maintain the temp. And acid strength for h2so4 production, if acid concentration high then so3, not absorb in molecules of water present in sulphuric acid, that means lot of stack eemission. 2 Is if low concentration of acid lot of heat is generate and due to heat absorption can not ddon, and it increase the pressure drop in absorption tower.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is minimum flow required of NG having BTU value of 920 btu/scf for flame stability of LBTU gas of BTU value 220 BTU/SCF against the flow 80KPPH.
How much maximum power can be generated by 320v, 10kg-cm synchronous motor if shaft is rotated mechanically at 50 to 60 rpm?
X is strong but has a very low density (1% of traditional earth materials.) and hence light weight. It is a recyclable material. The compression behaviour of X is strain rate dependent. Higher strain rates result in higher initial modulus and higher compression strength. It can also withstand unlimited number of cycling loading provided the repetitive loads are kept below 80% of the compressive strength. The internal structure of the material includes air-traps which make it poor heat conductor. X is non- biodegradable and chemically inert in both soil and water. Most acids and their water solutions do not attack it; however strong oxidizing acids do. Solvents which attack X include esters, ketones, ethers, aromatic and aliphatic hydrocarbons and their emulsions, among others. It does not support bacterial/fungal growth as well .It also has significant acoustic properties and effectively reduces the transmission of airborne sound. X is combustible and should not be exposed to open flame or other ignition sources. Combustion products are carbon monoxide, carbon dioxide, water and soot. Long-term exposure to sunlight causes yellowing and a slight embrittlement of the surface due to ultraviolet light. X is able to withstand the rigours of temperature cycling, assuring long-term performance.
What are the greenhouse gases in earth's atmosphere?
Name the some common problems associated with bellow expansion joints?
Difference between Synthetic foaming agents V/S Protien based foaming agent?
Plz if anybody has placement paper of HAL mail me i m Chemical engg my id er.kotnala@gmail.com
Explain the steps required to design a vapor-liquid separator or flash drum?
What is an effective means of removing silicon from aluminum?
When using a pumping loop to mix two miscible fluids in a tank, when can the content are considered well mixed?
When an expansion is joint needed on the shell side of a shell and tube heat exchanger?
What are the strategies acquired to cure tube vibration and exchangers in a shell?
What kind of concerns is associated with temperature pinch points in condensers?
What is the maximum recommend pipe velocity for dry and wet gases?
Define a barometric condenser?
