How can get electrical "c" licence.I am complited in
Deee.Passing year of 1993.Working in pvt cocern lt
Line.Please advise me .Cell no 9994786021
- 59 Answers
- 215678 Views
- Apollo Power, Chemplast, Christy Quality Foods, ITI, Mani Associates, Microtech Engineering, TAFE, Tamil Nadu Power Company, TechSun Energies, Thermax, I also Faced
- E-Mail Answers
Answer Posted / jaga
Hi have combeleted BE and tneb apprentice so i am eligible for c license
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
what does a string of resistors in a series will do?
How many types of circuit loads are there in a common electrical circuit?
Formulae for calculating the transmission line losses for different voltage levels
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
State any two nuclear power stations in India, with their generating capacity.
What is the method of estamating of cable, CB,MCB ?
why -48 volts dc used in telecommucation
What is CCM in Electrical ? where can we use this material?
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
How one can check the MAIN of a house wiring ?
