Answer Posted / manoj

Transducer it converts non electrical quantity (temp,press)
To an electrical quantity
Transducer can act as transmitter and receiver


Transmitter -it transmit signal one point to another point with a carrier signal added to original information

Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?

2722

---

Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?

2192

---

in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.

2751

---

Programmable Logic control.

1890

---

Calibration of controller (pneumatic)

1907

---

why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.

2330

---

how to calibrate 0- 150 psi presure gauge by dead weght tester

1938

---

why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.

2679

---

what deference between panel earth and systemearth

2278

---

How to Calibrate Level Switch in field

1251

---

what is the working principal of pribe

2239

---

When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

1765

---

How to decrease opening & closing time of on/off valve?

1441

---

key exchanges in wpa,wpa2,tls

1863

---

Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75 The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is: WARNING: Could not connect to equalize destination. (7001) Retrying. Number of retries = 0/1 ERROR: LdXopsLoadMain: connect error 10060 ERROR: Processing terminated due to connection error. (7002) Equalization end with errors. STN0149 ---- ERROR = 2 WARNING = 1 ---- Background: >Updated the ExaOPC software on the STN from 3.60 to 3.75 >STN operating system is Windows Server 2008 R2 >HIS operating system is Windows Server 2016 Stanard Solutions attempted include: >Ensuring all IP addresses are correct and all networked devices can be pinged. >The ability to ping a device using its host name from another device ( from HIS) >Ensure both devices firewalls are disabled. >The antivirus installed on the STN is disabled. >Ensuring both devices are within the same workgroup. >Added both devices to each other's Host and LMHost files. >Running IT Security tool after changing any administrative settings.

2138

---