Interested to Buy Any Domain ? << Click Here >> for more details...
what is plc? Basic function of plc? application of plc in
industry? What is lader diagram ? What is the main advantage
to use plc in industry?
- 15 Answers
- 106024 Views
- Schlumberger, I also Faced
- E-Mail Answers
Answer Posted / denish pastagia
Its Programmable Logic Controller, its a one kind of industrial Computer which is use to interface between Field input device and field Output Devices, Its Made for work in rough Environment, its microprocessor based Controller, With the using of Plc We can Develop Any Kind of Application like car manufacture unit, Bottle Filling Plant through Programming,
In Industry the mainly Use of PLC is like a main Controller Though Which We Controlled Every Instruments.
Its Reduces the Wiring Cost And The use of Plc We Easily Troubleshooting the Concept and Hardware.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
What is the use of gauge?
What is 1:1 redundancy ?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
What is force balance principle?
What is the use of control cable?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
where proximity sensor installed on tank in loading arm application
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what is zero and span ?
please tel me the calibration of pneumatic controler.
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
Why MUX JB's are using only Temperature Element in Fundation field bus?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
