Interested to Buy Any Domain ? << Click Here >> for more details...
what is the unit of hardness
- 3 Answers
- 12721 Views
- Kingfisher, TCS, Videocon, I also Faced
- E-Mail Answers
Answer Posted / amaran
HRC
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
What is the melting temperature of the cng long tube fusible plug? And can I use lead solder Sn97Cu3 (Melting temp S/L 227-309 °C) Materials of tube : AISI 4130 Alloy steel
Sir/Mam, I have applied for RRB chennai for the section engineer - mechanical posting. If any one is having the old written exam question papers please send it to my mail id : spramu@gmail.com Thanks in advance, Ramanathan...
Why consumption of lubricating oil is more in two-stroke cycle petrol engine than four-stroke cycle petrol engine ?
Write down the equation for conduction of heat through a slab or plane wall.
What is the cause of cylindrical liner overheating?
What for schmidt plot for is used in heat transfer problems ?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
how to calculate air load of a existing/ new plant before installing a air compressor.
SIR I M STUDENT OF POWER ENGG CAN I GIV PSU XAM 4 NTPC AND WHAT WOULD B THE PROCEDURE
How can one estimate the flow from a centrifugal pump after an accident where the pipe attached to the pump discharge breaks? Extrapolate the characteristic pump curve to H=0?
What is a machine shop?
If mft not act when spark failure 3 time what problem will happen in boiler side
What is pitting ? How it is caused ?
What is meant by lmtd?
why the people sitting in the train doesn't get shock whilethat man getting shock from top of the train?
