What is open loop and close loop?
Answer Posted / r_vaya
In close loop has directly control on output , in open loop not possible.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
field bus transmitter calibration procedure tell me
What is the minimum rating availalbe for weld neck orifice in market?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
What is ultrasonic flowmeter?
why is an oxygen sensor used in a boiler stack
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
what are the values of fuel flow rate in various places in boiler.
please send the sample qustion paper for iocl written test ..
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
Tell about your IFFCO plant visit.
What is the PLC configuration in Cement industry?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
What is force balance principle?