Interested to Buy Any Domain ? << Click Here >> for more details...
why use to 250 ohm for hart protocol and why hart communicator not communicate without 250 ohm
- 4 Answers
- 16136 Views
- OMV, I also Faced
- E-Mail Answers
Answer Posted / nilesh bhatt
Hart communicator work wen it gets minimum 5 volt and when it connects with 250 ohm resistance it gets excited and works online or offline.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
for oil & gas industries which zone is normally preferred? why? give its example?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
What are de-saturators?
What is stripper & spilitter ? Diffrence in this.?
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
KAlman filter code for two dimension?
2. What is ultrasonic flowmeter?
TEMPERATURE VARIATION FOR FREQUENTLY.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
How to decrease opening & closing time of on/off valve?
