Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tyrkrv83
Choosing the proper values for P, I, and D is called "PID Tuning".
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
what is piezoelectric transducer?give an example in power plant n state its principle?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
what are the diff. in servo and regulatory control?
KAlman filter code for two dimension?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
all types instrumentation questions want
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
what are the steps I have to deal with?
