what is the specific gravity of fully charged battery
- 14 Answers
- 14109 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepak ranjan mishra
it should be in the range between 1.15 to 1.25 when it is fully charged
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
What are the specifications for getting approval of Substation?
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
What is the suitable transmission voltage?
why HT armoured cable does not glanding
why and how current drawn by battery charger depends upon the altitude where it is located?
What are the limitations of Kirchoff's laws?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
What is electrical grounding?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
what types of electrical & mechanical test conducted in switchyard?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
