Interested to Buy Any Domain ? << Click Here >> for more details...
What is ALSPA 370 control system
- 1 Answers
- 5440 Views
- DUBAL-Dubai Aluminium, I also Faced
- E-Mail Answers
Answer Posted / jits_patel2002
ALSPA is the ALSTOM make DCS system..... which is used in the power industries
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
steps for installing orifice plate?
Why mixer nd grinder Is example of constant torque load not variable torque load ???
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
how to calculate range of level transmitter?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
how many types of preheaters are in cement industry & what r they can any body explain?
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
control panel design guidelines
