what is ZERO SUPPRESION and ZERO ELEVATION?
Answer Posted / ayaz
this term use for only when the transmitter mounting on up level on hp side or low level of hp side
when transmitter mount above on hp side tapping is called the transmitter is zero elevation
when transmitter installed below on hp side tapping is called the transmitter is suppression
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
whatis range of marcury filled tempereture gague
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
How to Calibrate Ultrasonic flow Transmitter in Field
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
what is dc moter.
Question on maha cement
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
what are the selections available in configuring a burnout protection of a controller? thanks
for oil & gas industries which zone is normally preferred? why? give its example?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,