Answer Posted / sarmadahmed
The direction of conventional current is always opposite to the direction of the electronic current. In history, it was assumed that the current is due to the flow of positive charges. When it was discovered that the current is actually the flow of electrons, already much work has been done by taking the opposite direction of current so scientists decided to go with the conventional current in future too.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
what is breathing?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
role of europe union in UK safety legistlation (electrical safety)
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
What is servo motor? what is its purpose?
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
Classify milling machines.
Why synchronous motor is used in power factor improvement,dc series in lift
why all the feeders are designed in a particular manner ... is there any reason for that???
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
What are the advantages & disadvantages of a group electrive drive?