Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / naveen joshi
Diode is semiconductor (p-n)material switch which allow to
flow current in one direction (reverse or forward) and
change the waveform current AC to DC.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
single phase power supply give to separate one steel coup with water, what reaction create
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
Which Class insulation is prefered for the sandwich Busducts ? Why?
What is the physical significant of power factor?
how to set relay setting? and example calculation...
Difference between earthing & grounding.?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
area control error
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
What is meant by turbo alternators?
what is the difference between an alternator and a synchronous motor
