1 cubic meter contains how many bricks
- 47 Answers
- 328558 Views
- Guru Tech, Krati Enterprises, L&T, I also Faced
- E-Mail Answers
Answer Posted / m.praveen kumar
one brick volume =(19*9*9*)c.m
=1539c.m^3
one side 1m wall volume =(100*100*19)c.m
=190000c.m^3
one side 1m wall consists one side 1m wall volume
= /
brick was one brick volume
190000c.m^3
= /
1539c.m^3
=123.45 =124nos
one meter cube consists of side of
wall =(4*124)
= 496 nos of bricks
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how do you calculate the length of "L" of main & distribution bar for reinforcing of raft footing
What is the difference between routing maintenance and major maintenance in school facilities?
Please tell me any one, how many quantity concrete paver block fixing perday ( 8hours) per mason??
plz drive the formula d2/162.162 for the calculation of weight of steel bars????
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Curvature ki quantity kaise nikalte hai pls give me ans... curvature canal ka hai
Why is the use of granular sub-base in concrete carriageways not preferred, explain?
Design a cantilever slab to carry a live load of 2000 N/m2. The overhang of the slab is 1.20m. b) A slab over a room is 4.75m x 4.75m. The edges of the slab are simply supported and the corners are not held down. The live load an the slab is 300 Kg/m2. The slab has a bearing of 15cm. On the supporting walls. Design the slab as per Rankine - Grashoff theory. Assume weight of R.C.C. = 2400 Kg/m2.
For The preparation of goverment examination Which book i will prefer and by which way i will do the preparation for exam.
I am practising engineer. I am searching for tutorial of RCC T Girder design Example in staad pro.Do anybody has this?please help
Explain what is progress payment?
what is the Asfalt test?in road constraction..?
What are the important hardware systems used for cad?
silt%= silt volume/ silt+sand volume is this right?
what is the water cement ratio for plastering
