Interested to Buy Any Domain ? << Click Here >> for more details...
What is the GNA & MNA in armature reaction of Dc Generator
- 2 Answers
- 22874 Views
- Khetan, I also Faced
- E-Mail Answers
Answer Posted / prerna ganjeer
emf zero induced in armature reaction in M.N.A
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
How would you relate your key competencies to this position?
Sate maximum power transfer theorem?
No load tap changing transformer working
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
what is vA rating and class of a ct.
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
Explain Continuous and Discrete signals?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
