Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between LPF and UPF wattmeter and
where it is used.
- 7 Answers
- 78680 Views
- I also Faced
- E-Mail Answers
Answer Posted / maniveer
LOW POWER FACTOR(LPF) & HIGH POWER FACTOR(UPF)
In open circuit test the secondary winding of transformer is kept open.As the secondary side is open, the entire coil will be purely inductive in nature.So the power will be lagging due to inductive property of the circuit. So LPF(Low Power Factor) Wattmeter is used in OPEN CIRCUIT TEST of Transformer.
In short circuit test the secondary winding of transformer is short circuited. As secondary side is short circuited the entire coil will be purely resistive in nature.So the power factor will be unity. So UPF(Unit Power Factor) Wattmeter is used in SHORT CIRCUIT TEST of Transformer.
| Is This Answer Correct ? | 258 Yes | 30 No |
Post New Answer View All Answers
what is errection pcbs?
What is stepper motor?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
How to check the cable fault / hv test of transformer cable.
What is a diode?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
what is two point starter?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
how pt is using
