Interested to Buy Any Domain ? << Click Here >> for more details...
why should a transformer be never connected to dc supply
- 5 Answers
- 8257 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhinav kumar
Ac voltage waveform is alternate so genrate a mutual induction and dc is direct current so it is not genrate mutual induction
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
Difference between transition and diffusion capacitance
What are the advantages of a three-phase system over a single-phase system?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
WHY RATING OF VCB NOT LESS THAN 630A
how we calculate the withstansing current capacity of wires&cables?
how we can calculate chiller required ampear?
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
why magnetising curve not start with zero voltage?
1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
There is any especial requirement for motor to drive through with VFD?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
