Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pankaj rathi
Instrumentation engg. is a branch of engg. which deals with measurement and control the physical & chemical properties of materials.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
In turbine what does term CDP, NH, HSSOC means.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
what is instrument philosophy
How to calibrate level transmitter with use of HART?
NSV type probe stands for
what are the diff. in servo and regulatory control?
What is motion balance principle?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Full form of KKS when use DCS.
kindly sent some demo question and answer
the output of the common trasmitter protocol in qatar gas are the following
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
How to calibrate smoke Dectector
