what is the formula to find out how many amps generater
takes running on full load.
- 4 Answers
- 6471 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.gurusamy
P=√3*V*I*0.8
P in KW
V=415V
I=?
ANS:
P=1.732*415*I*0.8
KW =575.024*I
KW/575.024=I
I=(0.00174*KW) AMPERE
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
What are the advantages of the three-phase motor over single phase motor?
1.4 What is meant by CT knee point voltage and how would you determine it
How to setting the volume of RTCC panel AVR (11kv) controller
why the rotor current becomes in steady state during high slip region? please verify with equations.
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
What is corkscrew rule?
What consists of 2 or more thermocouples to be connented series?
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
