Interested to Buy Any Domain ? << Click Here >> for more details...
in a plug point why the hole size at the top is large?
- 9 Answers
- 13327 Views
- Bhel, TCS, I also Faced
- E-Mail Answers
Answer Posted / ramkumar
we know that current always choose low resistance path. as
per the resistance formula when the cross section is large
ultimately the resistance is less. another reason is the
remaining pins are designed for carrying rated currents. say
6 A. the earth terminal designed to carry more than the
rated current during fault condition.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the purpose of stand by earth fault protection for transformer ?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
What conditions are required for transformer to operate at low frequencies ?
How are load losses and no-load losses measured at site in a DG set?
I am inpecting a 10kVA UPS what tests should i do and should i observe?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
Explain how you intend to work under pressure to meet up with deadline target?
What is called limb of a transformer?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
Explain the operation carried out in thermal power stations?
What is the difference between the relay and the circuit breaker?
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
