Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rathinavelu.k
Instrumentation is define as measured and monitor the Display unit...
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
Whatis the reset ofset and control system in instrumentation
What is the use of temperature compensation?
How digital input and digital output 's are working in dcs
KAlman filter code for two dimension?
Explain the key components of control loop?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
where cascade loop use ?
How to Calibrate Level Troll in field
this site is owned by an nonsense
in differential pressure transmitter,min&max pressure range for hp&lp
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
How oil line flow measured?eplain about instruments used and working principle?
