Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aallam
positioner convert 4-20 mA to 3-15 psi and by 3-15 psi control the supply air to the valve to open or close with help by feedback arm to correct the supply air to the vave
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which topics are covered in Process Control?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
What is limitation of the ht.of the displacer of a level trol?
Explain the difference between mmwc and mmwg?
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
what is temperature compensation?
How to calibrate Toxic gas detector?
Explain pH, Conductivity.
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
