Answer Posted / pundlik wanwe

for getting knee pint voltage of CT following is the procedure.
voltage source is connected to the CT secondary and slowly voltage is increased. milli ampere current is measured in the secondary circuit. at initial increase in current will be linear with voltage which is operating range. if again the voltage is increased further, at some point 10% increase in voltage causes 50% increased in current. this point is called Knee point of CT. Knee point is very important for the protection CT as after this point CT core is on the verge of saturation, which is not healthy region for protection.

What is reactive power and where it is used.

1642

---

What is the difference between alternator and generator?

1246

---

how to erect roof control panel?

1986

---

ht side line to earth voltage

1516

---

Why hydropower stations are preferred solution for meeting peak loads in grids?

941

---

Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?

2144

---

If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?

2025

---

How can find thermal state value in relay for calculate thermal overload.

1852

---

Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.

2303

---

Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.

1699

---

why you don not show protection and type of isolation in key single line diagram?

1922

---

What are diffrent type of road taxes?

1916

---

while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?

2816

---

what is a synchronizing lamp ?

1519

---

What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?

1917

---