Interested to Buy Any Domain ? << Click Here >> for more details...
All the voltage drops and the source voltage added together
in a series circuit is equal to
- 2 Answers
- 4212 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahesh
generated voltage or emf
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
what is lumped and distributed elements?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
EXPLAIN USE OF ROCKING ARRANGEMENT IN ELECTRIC HEATING?
how to get bearing & winding temperature of an induction motor?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
What is the difference between multimeter
how calculate gd2 of ht motors
difference between high and low impedance BUS BAR relay??
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
difrent between vcb acb sf6 and mccb breakers
Write the current equation in series RLC circuits.
why US countries maintains 110v and 60HZ
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
