why we don't use air circuit breaker on H T line in place of
vacuum circuit breaker ?
Answer Posted / sayyid ahamed pm
at the time of opening of cb more current and high voltages are causes to produce high arc due to air and moister are help to produce fire
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
how test transfomer(3 phase75kva) by megger
what is the use of permanent magnet generator in exciter
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
How phase displacement change in the over current relay coils.
Why we are going for converter transformers for DC drives application instead of distribution transformer?
What do you mean by lighting transformer?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
What is order of the system?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
how pt is using