Interested to Buy Any Domain ? << Click Here >> for more details...
why the weight of oil in transformer is specified (on the
nameplate) in litres as well as kilo grams?
- 3 Answers
- 5934 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / sasi karthick a
Liters is mentioned for quantity where weight in kg
mentioned for load details during foundation design.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
why electronic instruments is more favorable than electrical?
what is the ATS .And how it works.
Why should we hire you over the others waiting to be interview?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
how to define tell me about self
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Mention how NPN and PNP transistor works?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What is the working principle of MIG welding? and its out put Voltage?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
