in single phase circuit if i connect a heater between phase
and neutral, then what will be the current path? phase to
neutral or neutral to phase.
Answer Posted / ahamad kutty
SINCE AC IS ALTERNATE CURRENT IN EVERY HALF CYLE EACH
CONDUCTOR POLARITY IS CHANGED HENCE IT IS FROM PHASE TO
NEUTRAL FOR ONE HALF CYCLE AND FROM NEUTRAL TO PHASE NEXT
HALF CYCLE.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
how to flameproof electrical motor on the shaft?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
pls someone send me sample question papers along with the key.thanks in advance
Why do we use copper cable for HT Supply and why not Aluminium?
how we can calcultae the short circuit level for bus bar
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
As an electrical engineer what are the responsibilities which i can hold in TCS?
how to set relay setting? and example calculation...
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
what are the parameters plays a major role in Potential transformer Burden calculation??
How to measure the earth resistance value in a concrete pavement(flood light area)?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
What safety precaution are to be taken for avoiding electric hazards ?
why the value of k is more in shell typr transformers?