Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.ksharma
We have calibrate the cv ,using by I/p & positinor input signal 4-20 ma in I to p .positinor given the feed back to set point.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
what is function of switch, and how is it work, explain with difination
what is difference between HOT permit and cold permit
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
what is the importance of CV in the control valves? how it is calculated?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
how to calculate the total flow in square root
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
what is instrument philosophy
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
Explain bernoulli’s theorem. State its application.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
