Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mdmohsinayaz
Freruency is zero in dc F=0
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how cables go in and come out for distribution from the feeder pillar box?
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
How much of the total hydro power potential has been exploited so far in india?
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
Is Transol transformer oil comparable to nynas nytro libra?
why the check zone and main zone are used for Busbar Protn. scheem?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
what transformer we used normally and upto which kva?
what will happen if frequency is below 50 hz?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
why not starting switch first connect in direct on line starter?????
what will happen if i connect 12 volt battery with 24 volt battery charger.
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
