Interested to Buy Any Domain ? << Click Here >> for more details...
i am confusing about differential pressure transmitter as i
seen so many DPTs in different ranges how can we calculate
level and flow with mmh20 plz tel me
- 1 Answers
- 3684 Views
- I also Faced
- E-Mail Answers
Answer Posted / sathiskumar
FLOW calc:
flow is directly proportional to the square root of dp. this
is the actual technique currently we are following. but how?
normally for all the primary sensing element such as
orifice, Venturi there is a graph available from the
developer, which shows the values between dp vs flow graph.
based on this graph from the manufacturer the
instrumentation engineer will assign the range of dpx
accordng to the flow value of the curve.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How can a d.p. Transmitter be calibrated?
can we create an interrupt in plc through scada?
Explain the working principle of lvdt?
What is the use of each wire in three wire RTD
what is the calibration procedure for transweigh make weigh feeder?
How many ohms are required for proper earthing?
How to calibration coriolis flow meter?
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
How to Calibrate Vibration Probe (Axial, Redial) in field
how to relay switch sense the fault?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
where proximity sensor installed on tank in loading arm application
