what are different types of cables used in instrumention
how to calibrate a level transmitter online ( rosemount )
- 1 Answers
- 11139 Views
- I also Faced
- E-Mail Answers
Answer Posted / aswin
Mostly we r using F type and G type cable in instrumentation.
F type is individual and overall shielded.G type is over shielded.
Namely divided two type.Signal cable and control cable.signal cable carry 24vdc plus 4-20ma(AI/AO) . But control cable for DI/DO.24V DC,230AC,220 DC.Cable tray root also diff for diff signal.
| Is This Answer Correct ? | 23 Yes | 1 No |
Post New Answer View All Answers
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
Any one can help me to identified, how can we interchange the device in FF
What is mean by analytical instrumentation?
If we increase only P what will be controller action ?
What is zone,loop/fire alarm system?
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
What is Positive Calibration and Negative Calibration?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
how to calibrate corollaries (Mass flow meter)?
What is megering????
Explain the working principle of lvdt?
What is the procedure of calibration of Load cell?
Please asked me How calculate DCS controller memory.
