Interested to Buy Any Domain ? << Click Here >> for more details...
why CT ratio stand for 50/5, 100/5, 25/5.
- 11 Answers
- 68790 Views
- ABB, Ramky, I also Faced
- E-Mail Answers
Answer Posted / rohitash saini
c.t is a current transfarmer which measure electrical current in system. we identify it just that 100/5than the ratio 20:1
that is when primary taken 20 amps current then secondary turn taken 5amp.when we put c.t ratio in digital meter after he showing direct reading .
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
Vaccum circuit breaker
How can we choose the rating of submersible motors
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
for a 400kv t/m line with 10 ampere current will corona occur?
What is the relation between frequency and motor rpm?
how much excitation voltage required to generate 1mw power?
What are PLC leader logic program method
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
